Skip to content

Room

Check spacing and measure the room

Updated October 30, 2026

Check spacing

  1. In Room, click Spacing in the toolbar above the plan. The number beside it counts what needs a look.
  2. Problems are marked on the plan: a line across each tight gap, and a dashed outline around other tables to check.
  3. Click an empty part of the floor and open Spacing in the Room panel for the full list. Click an item to select its tables.
  4. Move the tables. The list updates as you go.

What's checked

  • Chairs at two tables overlap.
  • Less than about 18 inches (45 cm) between the chairs of two tables, so guests can't pull them out.
  • A table that reaches past the walls.
  • A table sitting on the dance floor, stage, bar or another piece.
  • Less than about 44 inches (1.1 m) clear in front of a door, entrance or fire exit. Overlapping chairs and blocked fire exits come first in the list.
  • A guest with access needs at a table without a 36-inch (90 cm) route to their place. This is a reminder to check, so it isn't counted in the toolbar.

When everything is clear, the list says everything has room to breathe.

Measure

  1. Click Measure in the toolbar.
  2. Drag from one point to another. The distance shows on the line, in feet and inches or in meters.
  3. Drag again to measure something else, then click Measure again, or the cross on the hint, to finish.

Placing things precisely

Tables snap to a grid as you drag. Hold Alt while dragging to place freely, or untick Snap in the corner of the plan. Arrow keys nudge what's selected; hold Shift for bigger steps.

Try it on a sample planThe demo opens the Room step with guests already added. Nothing you do there is saved.

Open the demo

Was this helpful?